Troubleshooting - Conair MN253WCSC Operating Instructions Manual

Table of Contents

Advertisement

SAVE THESE
INSTRUCTIONS

TROUBLESHOOTING

T
here are several things to look for if your trim-
mer fails to operate:
1. Be sure the trimmer is turned ON.
2. Check if trimmer head is properly placed
and aligned.
3. Check the blades to see if they are clogged
with hair clippings; if so, use the cleaning
brush to remove hair.
4. If the trimmer still fails to operate, take or
send it to a Conair Service Center (see
warranty procedure and addresses).
If your rechargeable trimmer does not
seem to be taking a charge, take the follow-
ing troubleshooting steps before returning it
for repair:
1. Be sure the electrical outlet is working, by
plugging in another appliance to test it.
2. Make sure the electrical plug is not
connected to a switch which turns power
off when lights are turned off.
3. Be sure you have inserted the trimmer
properly into the charging stand, that all
connections are secure, and that the trim-
mer switch is in the "OFF" position.
Do not attempt to charge this unit with the
switch in the "ON" position. It can damage
your unit and the unit will not charge.
FOR HOUSEHOLD
USE ONLY
OPERATING
INSTRUCTIONS
FOR YOUR RECHARGEABLE
TRIMMER
CHARGING THE MN253WCSC
1. Before using your trimmer for the first time,
insert the trimmer in the charging base and
then plug into wall outlet and charge it for 16
hours. Always place the trimmer in the stand
with the ON/OFF switch in the OFF position.
2. Always check to see if the charging light is on
when the cord is connected to the trimmer
and the unit is not in use.
3. Plug unit into any 120V, 60Hz wall outlet.
4. The trimmer can remain plugged into the
power source at all times without damage to
the battery.
5. To use your trimmer, push ON/OFF switch
upwards to "ON" position.
6. After you finish using your trimmer, push
down on the ON/OFF switch to turn the trim-
mer off.
7. If, while trimmer is in use, the charge seems
to be running down, simply put ON/OFF
switch in OFF position. Then, insert the trim-
mer in the charging base and plug into wall
outlet. Allow battery to recharge for several
hours.
8. To maintain the full charging capacity and
extend the life of the battery, it must be peri-
odically run down during normal use
stops, then recharge.
until it

Advertisement

Table of Contents
loading

Table of Contents