Troubleshooting - Conair MN250 Instructions Manual

10. Do not use the appliance outdoors or
operate where aerosol (spray) products are
being used or oxygen is being administered.
SAVE THESE
INSTRUCTIONS

TROUBLESHOOTING

There are several things to look for if your
trimmer fails to operate:
1. Be sure the trimmer is turned ON.
2. Make sure that the battery is properly
placed in the battery compartment. Test the
battery to be sure it is working. (For MN250
models)
3. Check the blades to see if they are
clogged with hair clippings; if so, use the
cleaning brush to remove hair.
4. If the trimmer still fails to operate, take or
send it to a Conair Service Centre (see war-
ranty procedure and addresses).
If your rechargeable trimmer does not
seem to be taking a charge, take the
following troubleshooting steps before
returning it for repair:
1. Be sure the electrical outlet is working, by
plugging in another appliance to test it.
2. Make sure the electrical plug is not
connected to a switch which turns power off
when lights are turned off.
3. Be sure you have inserted the trimmer
properly into the charging stand, that all
connections are secure, and that the
trimmer switch is in the "OFF" position.
FOR HOUSEHOLD
USE ONLY
OPERATING INSTRUCTIONS
FOR YOUR MN251 MODELS
RECHARGEABLE TRIMMER
Check to be sure which model
you have purchased.
1. Before using your trimmer for the first
time, insert the trimmer in the charging
base and then plug into wall outlet and
charge it for 16 hours. Always place the
trimmer in the stand with the ON/OFF switch
in the OFF position.
2. Always check to see if the charging light
is on when the cord is connected to the
trimmer and the unit is not in use.
3. Plug unit into any 120V, 60hz wall outlet.
4. The trimmer can remain plugged into the
power source at all times without damage to
the battery.
5. To use your trimmer, push On/Off switch
upwards to "On" position.
6. After you finish using your trimmer, push
down on the On/Off switch to turn the
trimmer off.
7. If, while trimmer is in use, the charge
seems to be running down, simply put
ON/OFF switch in OFF position. Then, insert
the trimmer in the charging base and plug
into wall outlet. Allow battery to recharge for
several hours.
8. To maintain the full charging capacity and
extend the life of the battery, it must be