Getting Started; Battery Removal - Conair MN253WCSC Operating Instructions Manual

9. The charge base may become warm while
charging – this is normal.
10. A fully charged trimmer will give approxi-
mately 15-20 minutes of trimming time.
NOTE: When traveling there is no need to take
the stand. Just plug the cord directly into the
base of the unit with the switch in the "OFF"
position and the unit will charge.

BATTERY REMOVAL

C
ONTAINS NICKEL CADMIUM
BATTERY. MUST BE COLLECTED,
RECYCLED OR DISPOSED OF
PROPERLY. DO NOT DISPOSE OF IN
THE MUNICIPAL WASTE.
Bring the batteries with the handle of the trim-
mer to the nearest collection center for proper
disposal. DO NOT throw the battery into the
normal municipal waste system.
TYPES OF BEARDS/MUSTACHES
GROWING A BEARD OR MUSTACHE
There are three key factors that determine
which beard or mustache style is most suitable
for your face:
1. The shape and dimensions of your face.
2. The natural growth of your beard/mustache.
3. The thickness of your beard/mustache.
If you are unsure of the type of beard or mus-
tache that most suits your face, speak with a
professional hair stylist and ask for an opinion
on what style would be best. Once your beard or
mustache has been styled, it is essential that you
maintain its appearance. To do this, use your
shaper to trim your beard/mustache weekly.
For the best trimming results, your beard
should be slightly damp (not wet) before using
the trimmer. This will prevent the trimmer from
removing more hair than desired.
CAUTION
Do not immerse any part of the charging stand
or the adapter in water.
Do not try to plug the adapter into an AC outlet
while your hands are wet.
The outer foil and inner blades of the shaver are
delicate and must be handled very carefully.
The foil of the shaver head is extremely thin and
precision crafted. Do not push on the foil when
inserting the trimmer into the charging stand.

GETTING STARTED

TO SWITCH TRIMMER HEADS
Hold the trimmer handle with the back of the
trimmer facing you.
With your other hand; twist the head counter
clockwise, then puling straight away ( Fig. 1)
Attach another head by inserting it down on top,
align the triangle on the trimmer head with the
circle on the side of the handle and turn clock-
wise until the dot is aligned (Fig. 2).