Advertisement
STEP 5
- Insert cap with can attached
into base and turn to lock
gel position
gel
nozzle
gel release
button
- Properly installed gel unit
lather release
control cap
lather nozzle
lather
position
- Properly installed lather unit
IMPORTANT:
Oversize lather can may not fit into the base provided.
The cap will work on the lather can without the base.
Caution: Do not block dispenser nozzle with hand,
as hot steam may be emitted during use or when
the can of gel is low. Replace can when gel is run-
ning low. Hold hand to side and under, not in front
of dispenser.
Once you have shaved, turn the unit off, by pressing the
OFF button. Be sure to unplug the unit when not in use.
USING LATHER
• Make sure Lather Nozzle for Lather and insert
Lather can into machine as "VERY IMPORTANT SET-
UP INSTRUCTION"
• Push the power 'on' button on the top of the
machine.
• After a few minutes, the ready indicator will light.
• Press down on the top of the machine to dis-
pense heated lather into the palm of your hand.
• Spread lather over your face as usual for a com-
fortable hot shave.
USING GEL
• Make sure Gel Nozzle for Gel and insert Gel
can into Machine as "VERY IMPORTANT SET-UP
INSTRUCTION"
• Push down on the top of the machine. At the
same time, slide the #3 "adjustment switch" until
the top is locked in place; this will release gel into
the machine to be heated
• Push the power 'on' button on the top of the
machine.
• After a few minutes, the ready indicator will light.
• Press the gel release button on the nozzle to
release heated gel into the palm of your hand.
• Spread gel over your face as usual for a comfortable
hot shave.
TO REMOVE CAN
When can is empty or when using for travel, it will
be necessary to remove the can from the machine.
1. Be sure the machine is unplugged from the
outlet.
2. With one hand holding the can, remove the
machine and can from the protective cylinder.
Then depress the locking tab with the other hand
and pull the machine off the top of the can.
3. Clean the machine with a damp cloth.
DO NOT IMMERSE THE MACHINE IN WATER!
TROUBLESHOOTING GUIDE
Problem: Gel or lather is too runny.
Solution: Adjust temperature control dial to a lower
setting.
Problem: Unit fails to heat.
Solution: Make sure the unit is plugged in and
turned on. Top red light should be on. After 1 to 3
minutes or until the red light glows solid, the unit
is ready to dispense hot gel/lather.
Problem: Unit will not dispense lather.
Solution: Unit is not properly mounted to the can.
Remove unit from can, then reattach, making sure
that the unit is securely attached to the top of can
or check the lather can is using the lather nozzle
and perfectly locked.
Problem: Unit will not dispense gel.
Solution: Unit is not properly mounted to the can.
Remove unit from can, then reattach, making sure
that the unit is securely attached to the top of can
or check the gel can is using the gel nozzle and
perfectly locked.
Problem: The gel/lather is too hot or too much
steam emitted.
Solution: Adjust temperature control dial to lower
setting, or replace can if it has a low amount of
gel/lather.
Advertisement
