Repair And Service - DeWalt D28410 User Manual

E N G L I S H
• Pull the spring-loaded tab (18) to unlock the
rotary mechanism (fi g. E1). Hold the tab in the
pulled-out position.
• Rotate the handle (19) into the desired position
(fi g. E2).
• Release the tab and lock it in position.
• Check that the rotary mechanism is locked.
Do not use the tool unless the rotary
handle is in the locked postion.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer fl ange are mounted
correctly.
• Make sure the disc or wheel rotates in the direction
of the arrows on the accessory and the tool.
Switching on and off (fi g. A)
The on/off switch is equipped with an unlocking
switch or a locking switch for continuous operation.
On/off switch (1) with locking switch (2)
• To run the tool, depress the locking switch (2)
and subsequently operate the on/off switch (1).
• Release the locking switch (2).
• To stop the tool, press the on/off switch again.
On/off switch (1) with unlocking switch (2)
(France, Australia and New Zealand)
• To run the tool, depress the unlocking switch (2)
and subsequently operate the on/off switch (1).
• Release the unlocking switch (2).
• To stop the tool, release the switch.
10
Do not switch the tool on or off when
under load.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized D
where it will be disposed of in an environmentally
safe way.
D WALT AFTER SALES SERVICE
E

REPAIR AND SERVICE

All D WALT power tools are thoroughly tested
E
before leaving the factory. However, if the power
tool needs repair, please contact your dealer or
take it to your nearest D WALT Service Centre.
E
There is a Service Centre in every capital city.
For service, repair or parts call 1800 654 155
(Aust) or 02 259 1111 (NZ).
WALT repair agent
E