The Grip Belt; Using The Lens Cover; Power Supply - Panasonic Palmcorder PV-GS90P Operating Instructions Manual

The grip belt

Adjust the belt length so it fits your hand.
1
Adjust the belt length and the pad position.
1 Flip the belt.
2 Adjust the length.
3 Fix the belt.

Using the lens cover

For the lens protection, be sure to close the lens
cover when not in use.
1
Slide the lens cover open/close switch to
[ ].
12
LSQT1284
Before using

Power supply

ª
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
IMPORTANT:
≥If the DC Cable is connected to the AC adaptor,
then the battery will not get charged. Remove
the DC Cable from the AC adaptor.
≥Battery charging time. (
≥We recommend using Panasonic batteries.
( , )
-8- -51-
≥If you use other batteries, we cannot guarantee
the quality of this product.
1
Connect the AC Cable to the AC adaptor
and the AC Jack.
2
Insert the battery into the battery charger by
aligning the arrows.
2
ª
Charging lamp [CHARGE]
Lights up: Charging
Goes off: Charging completed
Flashing: ≥ When the battery temperature is
excessively high or low, the lamp
flashes and the charging time will be
longer than normal.
≥ Remove dirt, foreign objects or dust
on the terminals of the battery or the
AC adaptor.
If the lamp is still flashing, something
may be wrong with the battery or AC
adaptor.
Contact consumer support.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
)
-13-
1
-55-