Ryobi RLM4617ME Original Instructions Manual page 12

WARNING
Do not store the product with petrol in the tank inside
a building where fumes may reach an open fl ame or
spark.
2. If not using fuel stabilizer, allow the engine to run until
the product is completely out of petrol.
3. Once the engine has stopped, allow the blade to come
to a complete stop and disconnect the spark plug wire.
4. Turn the fuel tap to the closed position.
5. Check all nuts, bolts, knobs, screws, and fasteners for
tightness.
6. Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
7. Store the product in a well-ventilated area that is
clean, dry, and out of the reach of children.
8. Do not store near corrosive materials such as fertilizers
or rock salt.
To lower the handle before storing
1. Loosen the starter rope guide knob. Remove starter
rope from guide and allow to retract into engine.
2. Fully loosen the handle knobs on the sides of the
handle and fold the upper handle down.
3. Remove the handle knobs and bolts from each side of
the lower handle in the handle bracket, (mounted on
the mower deck).
4. Push inward on each side of the lower handle, and
lift the sides of the lower handle past the edges of the
handle mounting brackets.
5. Fold the lower handle forward, making sure not to
bend or kink the control cables.
TRANSPORTATION
1. Stop the product, disconnect the spark plug wire, wait
until the blade comes to a complete stop, and allow
the product to cool.
2. Empty the fuel tank by running the engine until it stops.
Empty oil by following the instructions for changing oil.
See steps 1-2 in Changing the Engine Oil.
3. Secure the machine against movement or falling to
prevent injury to persons or damage to the machine.
11