Table of Contents
Advertisement
Chapter 2
Installing the Server
Reversing the Cable Management Arm (Optional)
Step 1
Rotate the entire CMA assembly 180 degrees. The plastic cable guides must remain pointing upward.
Step 2
Flip the tabs at the end of each CMA arm so that they point toward the rear of the server.
Step 3
Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the
outside of the tab and pivot the tab 180 degrees so that it points toward the rear of the server.
Figure 2-5
1
OL-32474-01
Reversing the CMA
2
CMA tab on end of width-adjustment slider
1
2
Metal button for rotating
Cisco UCS C240 M4 Server Installation and Service Guide
Installing the Server In a Rack
2-9
Advertisement
Table of Contents
