Table of Contents
Advertisement
ECOWATER
S Y S T E M S
SETTING RECHARGE TIME
When the conditioner/refiner's electronic control is first
powered up, the default time for starting an automatic
recharge is 2:00 a.m. This is a good time in most
households because water is not being used. To
change this time:
1. From any of the rolling status screens, press the
SELECT (¡) button to display the Main menu.
2. Press the DOWN (6) button to scroll through the
menu options until Basic settings is highlighted
(See Figure 99).
3. Press the SELECT (¡) button to display the Basic
settings menu (See Figure 100).
4. Press the DOWN (6) button to scroll through the
menu options until Recharge time is highlighted.
5. Press the SELECT (¡) button to display the
Recharge time screen (See Figure 101).
6. Press the UP (5) or DOWN (6) buttons to change
the recharge time in 1 hour increments. Hold the
button down to rapidly advance. Be sure that AM or
PM is correct (unless conditioner/refiner is set for a
24-hour clock).
7. Press the SELECT (¡) button. The display will go
back to the Basic settings menu (Figure 100).
8. Press the LEFT (3) button twice to return to the
rolling status screens.
SETTING HARDNESS
When the conditioner/refiner's electronic control is first
powered up, a "wizard" screen prompts you to enter your
water's hardness (See Page 10 or 13). To change it:
1-3. Go to the Basic settings menu by following Steps
1-3 in "Setting Recharge Time" at left.
4. Press the DOWN (6) button to scroll through the
menu options until Hardness is highlighted.
5. Press the SELECT (¡) button to display the
Hardness screen (See Figure 102).
FIG. 99
6. Press the UP (5) or DOWN (6) buttons to set the
value for your water's hardness. Hold the button
down to rapidly advance.
NOTE: Do not increase the hardness setting to
7. Press the SELECT (¡) button. The display will go
FIG. 100
back to the Basic settings menu.
8. Press the LEFT (3) button twice to return to the
rolling status screens.
SETTING IRON LEVEL
When the conditioner/refiner's electronic control is first
powered up, a "wizard" screen prompts you to enter your
water's iron level (See Page 11 or 13). The conversion
is 3 grains per ppm of clear water iron. To change:
1-3. Go to the Basic settings menu by following Steps
1-3 in "Setting Recharge Time" at left.
FIG. 101
4. Press the DOWN (6) button to scroll through the
menu options until Iron level is highlighted.
5. Press the SELECT (¡) button to display the Iron
level screen (See Figure 103).
6. Press the UP (5) or DOWN (6) buttons to set the
value for iron in your water. Hold the button down to
rapidly advance.
7. Press the SELECT (¡) button. The display will go
back to the Basic settings menu.
8. Press the LEFT (3) button twice to return to the
rolling status screens.
28
Conditioner/Refiner Operation
compensate for iron in your water. The
electronic control compensates automatically
after you set the iron level, below.
FIG. 102
FIG. 103
Hide quick links:
Advertisement
Table of Contents
