Get Started; Connect Speakers; Connect Power; Prepare The Remote Control - Philips FX10 User Manual

3 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
laser exposure or other unsafe operation.
Always follow the instructions in
this chapter in sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Connect speakers

Note
•
For optimal sound, use the supplied speakers only.
•
Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Specifications section of this manual.
Note
•
Make sure that the colors of the speaker wires and
terminals are matched.
Insert the wire completely.
• Insert the right speaker wires to "R",
and left speaker wires to "L".

Connect power

Caution
•
Make sure that the power supply socket used can
support at least 10A current loading.
•
Before connecting the AC power cord, make sure that
you have completed all the other connections.
1
Adjust the voltage selector on the back of
the main unit to match your local power
supply.
2
Connect the AC power cable to the wall
socket.

Prepare the remote control

Note
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type.
EN 9