Verifying The Unit Is Correctly Recognised By The Computer - Panasonic HDC-DX1 Operating Instructions Manual

With a computer
Verifying the unit is correctly
recognised by the computer
To verify this unit is correctly recognised by the
computer, rotate the mode dial on this unit to
select PC connection mode, then connect the
unit to the computer with a USB cable and follow
the steps below.
≥With some computers including those made by
NEC, the Device Manager may not be
displayed if a mode that places restrictions on
the functions has been established. Consult the
manufacturer or follow the steps in your
computer's operating instructions to establish a
mode in which all the functions can be used,
then proceed with operation.
1
Select [start]
[Control Panel]
and Maintenance]
2
Click the [Hardware] tab, then
click [Device Manager].
100
VQT1A15
([Settings] )
# #
([Performance
#
) [System].
#
3
Verify the following items are
displayed.
ª If the driver has been recognised
properly
[USB Mass Storage Device] is displayed at
[Universal Serial Bus controllers].
ª If the driver has not been
recognised properly
[!] or [Unknown device] appears at [Universal
Serial Bus controllers] or [Other devices], etc.
(Where the display will appear depends on the
type of computer you are using.)
You can use the following method to enable it to
be recognised.
Method 1: Turn off the unit and your computer
once and try again.
Method 2: Eject the SD card and try verifying
again.
Method 3: Try connecting the unit to another
USB port on your computer.