TrekStor MovieStation Antarius User Manual page 45

I want to copy files onto an external data storage device with my Moviestation,
but I always get an error message.
To use the copy function of your MovieStation, the device (or the partition) on which you want
i
to copy data must be formatted with the FAT32 file system.
Please use only targets formatted with FAT32 for copying onto.
I have connected the Moviestation to my television or my hiFi system. Why is no
picture showing on my television or no sound coming from my hiFi system?
This problem may have several causes. Please check the following items:
i
1) Please ensure that you have selected the correct AV source on your television set.
2) Please check that you have connected the correct cable for the output of the video and
audio signals. Information on the correct connection of the MovieStation to your home
entertainment system can be found in the "Connecting the TrekStor MovieStation to the
Home Entertainment System" chapter in these operating instructions.
3) Even if you have correctly connected the MovieStation, it is possible that it may be in the
incorrect video output mode. To select a different mode, press the "TV-OUT" button. Wait
a few seconds until the MovieStation and your television have implemented the change.
Repeat this procedure until the picture is correctly displayed on your television.
Why mustn't I disconnect the Moviestation from the mains supply without having
switched if off beforehand?
The loading or saving of the current system settings takes approx. 15 seconds when the
i
MovieStation is turned on or off. If the MoveStation is disconnected from the mains supply
without having beem switched off beforehand, settings and data may be lost. Please always
switch off the MovieStation by pressing the
and wait until the
Why is the button still lit in blue even though I have switched it off?
/
The loading or saving of the current system settings takes approx. 15 seconds. The illumination
i
of the button changes to red only after all settings have been saved and the MovieStation
/
has entered the standby mode. If you want to, you can then disconnect the MovieStation from
the mains supply.
the language of the user interface has been changed. how do I change the language?
In order to change the selected language, enter the "S
button on your remote control. Select the right menu ("S
your remote control. The available languages are displayed. Please mark the desired language
and confirm your choice by pressing the
While using the Moviestation, it no longer responds to my commands.
This problem may have several causes. Please check the following items:
i
1) Please aim the remote control in the direction of the MovieStation so that direct visual
contact between these two devices exists and ensure that the infrared receiver of the
remote control and the MovieStation are not covered.
2) Check the battery in the remote control and, if necessary, replace it with a new one.
Why is it possible that there are interruptions when playing movies from my local
network?
Sometimes, there are several devices in a network that have to share the maximum data
i
transfer rate possible via a network connection (shared medium). If there are several
connections active in the network you use the MovieStation in (e.g. to the internet, a shared
printer, etc.), it is possible that this lowers the data transfer rate available for the streaming of
the data to the MovieStation to a level that is insufficient for the playback of e.g. a DVD file or
an HD movie file.
Should you experience such problems, please try to reduce the amount of data transferred by
other users of your network.
button on the MovieStation lights up red.
/
z
button on the device or on the remote control
/
" menu by pressing the "SETUP"
ETTINGS
") and press the
YSTEM
button.
button on
z
En
45