Advertisement
Warnings!
l The width of the Adjuster Bolts on each side must be set equally to avoid
unexpected accidents and/or product damage as shown in Figure 4.
l Tighten the Adjuster Knobs until clearance between the Gate Door and
Main Frame is set to 0.12" (3mm). This allows the tension-spring effect
to work properly to avoid unexpected accidents and/or product damage.
Figure 5
Side of the Main Frame
should be parallel to the wall.
7. Installation Check/How to Open and Close the Door
1. When correctly installed, the gate should not feel loose or wobbly when tugged.
2. After assembly, open/close the Door several times to make sure the Door
works properly (please see Figure 6).
3. For the Door to lock properly, the Door Handle must snap into the Upper Door
Stopper when lifted and released. Make sure the Door locks properly.
4. Make sure that Lower Door Stopper is centered over Main Frame's lower bar,
and locks in place securely.
8. How to Disassemble
Rotate Adjuster Knobs counterclockwise to loosen and remove.
Cautions!
lBe careful not to drop the product during disassembly.
lMake sure the Door is locked during disassembly.
9. How to Clean
l
Use a mild detergent and water and clean with a soft cloth/sponge. Cleaning with a scrub brush and/or using a polishing
powder may cause scratches, rust and/or discolor this product.
l
When using creosol or other disinfectants, make sure to dilute them, otherwise damage to the bamboo finish or discoloration
may occur.
l
Do not use harsh chemicals such as thinner, benzene or alcohol as these may cause damage/discoloration to the bamboo finish.
l
After cleaning, wipe dry with soft cloth or place in a shaded area to air dry; do not place product in direct sunlight.
10. Specifications
Product Name
Product Size
Product Weight
Material
lPlease note that product specifications and design may change without prior notice for the purpose of quality improvement.
660071
One side of Adjuster Knob
is longer than other side.
Také One-Touch Pet Gate
XX - XX x X x XXH" (XX - XX x X x XXHcm)
XXlbs
Main Frame, Side Frame, Option Frame: XX
Door: XX
Plastic Parts: XX
Adjuster Knob: XX
Adjuster Bolt Metal Part: XX
Adjuster Bolt Rubber Part: XX
If you find something wrong with this product, please let us know. Thank you!
Replacement parts may be purchased by contacting Richell USA directly at the number listed
below or at www.richellusa.com.
Designed by:
Richell Corporation, Japan
About 0.12" (3mm)
Figure 4
One side of Adjuster Knob
is shorter than other side.
Figure 6
Main Frame
Distributed by:
Richell USA Inc.
2100 N. Hwy. 360, Suite 1700, Grand Prairie, TX 75050
Phone (972) 641-9795
Visit us at
Made in China
4
Adjuster Bolts on
each side must be
set equally
Door
Main Frame
Side of the Main Frame
should be parallel to the
wall surface.
Door Handle
Upper Door Stopper
Lower bar
Fax (972) 641-8495
www.richellusa.com
Lower Door
Stopper
1101
Advertisement
