Advertisement
Type A
Adjuster Knob
Long Adjuster Bolt
For an opening width of 28.3 - 29.6" (72 - 75cm)
Type A
Insert
Body
Long Adjuster Bolts
Adjuster Knobs
Type A
Insert
For an opening width of 31.1 - 33.5" (79 - 85cm)
Type B
Insert
Body
Long Adjuster Bolts
Adjuster Knobs
Side Frames (2)
Hexagon Nut (8)
Type B
Insert
Cautions!
l
Do not use 2 Side Frames on the same side.
6. How to Install the Gate
Important!
Make sure the bottom of the Main Frame touches the Floor.
*The top width of the frame may be wider than the wall since the product is designed to be installed using a tension-spring effect.
If necessary, use force to make the top of the gate narrower to fit between the wall as shown in Figure 1.
1. Determine the desired direction for the door opening. Set the product against the wall at a perpendicular right angle as shown in Figure 2.
Tighten the upper Adjuster Knob until the rubber of the Adjuster Knob touches the wall surface as shown in Figure 3.
2. Tighten the upper Adjuster Knobs on each side until clearance between the Gate Door and Main Frame is set to about 1.2"(3mm) as shown in Figure 4.
3. Tighten the lower Adjuster Knobs to give enough tension force. Then install the product against the wall vertically as shown in Figure 5.
Type B
Hexagon Nut
Long Adjuster Bolt
Side Frame
Type A
Insert
Required Parts
(1)
(4)
(4)
Type A
Insert
Type B
Insert
Required Parts
(1)
(4)
(4)
Type B
Insert
Cautions!
l
The bottom of the product should contact the floor for safety as shown in Figure 1.
l
If the product has been installed correctly, the top of the gate (while looking down from above the top)
will be as straight as a line with each end aligned at a 90-degree right angle as shown in Figure 2.
Use force to make
the top of the gate
narrower.
Figure 1
Type C
Adjuster Knob
For an opening width of 29.6 - 31.1" (75 - 79cm)
Type B
Insert
Type B
Insert
For an opening width of 33.5 - 35.8" (85 - 91cm)
Type B
Insert
Type B
Insert
90° degree
90° degree
Figure 2
3
Adjuster Knob
Joint
Hexagon Nut
Side Frame
Required Parts
Body
(1)
Long Adjuster Bolts
Adjuster Knobs
Side Frame
Hexagon Nut (4)
Insert
Required Parts
Body
(1)
Long Adjuster Bolts
(2)
Short Adjuster Bolts
(2)
Joints
(2)
Adjuster Knobs
(4)
Side Frame
(2)
Option Frame
(1)
Hexagon Nut
(8)
Insert
2.4" and above
Adjuster Knob
Less than 2.4"
Tension force
Rubber
Short Adjuster Bolt
Option Frame
Type A
Insert
(4)
(4)
(1)
Type A
Insert
Type C
Type C
Clockwise
rotation
Figure 3
Advertisement
