Set Up Relay Output; Relay Sources - ABB COMMANDER 1900 Series Programming Manual

...3 BASIC CONFIGURATION LEVEL

...3.5 Set Up Relay Output

SEt UP
rELAYS
SELECt
rLY 1. 1
Module Position
Relay No.
NONE
NONE
SOUrCE
EQN–4
NONE
NONE
POLrtY
POStVE
NEGtVE
SELECt
16
Page Header –
Set Up Relays
To advance to
Set Up Digital Output Page
Select Relay Output
Select the output to be programmed. The selections in this frame relate to the number of fitted
modules with relays and their relative module positions.
– for a type 3 (four relays) module fitted in position five the following selections are also
Example
programmable:
rELAY 5. 1 (position 5, relay 1)
rELAY 5. 2
(position 5, relay 2)
rELAY 5. 3 (position 5, relay 3)
rELAY 5. 4 (position 5, relay 4)
Note. In the remaining frames press the
Relay Source
Select the source required to activate the selected relay.
For description of sources, refer
Note.
• Time proportioning control can only be allocated to the first two relays on a type 3 (4 relay)
module or the relay on types 1 and 2 modules (standard I/O and analog + relay).
• To drive an external counter
Polarity
The polarity selection is used to invert the effect of the digital source state on the relay state as
shown in the following table:
S o u c r e S a t e t
A c v i t e
N o n a - c v i t e
Select the polarity required
Caution. Check connections before operating – see Section 6,
Return to
Select Relay Output
press the switch.
switch to view the relay selected.
on page 17.
to Table 3.1
COUNt. x must be selected.
P o a l i r y t
P o i s v i t e
N e g a v i t e
P o i s v i t e
N e g a v i t e
frame.
R e a l y S a t e t
E n e g r z i e d
D e e - n e g r z i e d
D e e - n e g r z i e d
E n e g r z i e d
CONNECTIONS & LINKS
.