Sirius Satellite Radio SIRIUS STILETTO 2 Installation & User Manual page 44

Vehicle kit
Hide thumbs Also See for SIRIUS STILETTO 2:
Table of Contents

Advertisement

REMOVE
ADHESIVE BACKING
FROM ARROW
REMOVE BOTH SUCTION CUPS
THIS THINNER PORTION OF THE FEA SHOULD BE
TAUT WHEN THE FEA IS PERMANENTLY ADHERED
Step 9: Route and hide the cable through the vehicle to
your SIRIUS radio
Hide most of the cable by properly routing the antenna cable to your SIRIUS radio. (Figure
31) Use the cable guides to hold the cable in place until it reaches the inner trim or moulding
at the edge of the window. Take advantage of any existing cable channel or wiring conduit
and route the cable around the passenger compartment to the vehicle dock. Take care not
pull the cable across sharp edges that could damage it, and keep it away from areas where it
might entangle feet. Coil and secure any excess antenna cable in a location where it can be
hidden and secured (such as under the carpet or floor mat). Make sure the FEA is plugged
into the FM OUT connector of the radio or vehicle dock.
This completes the FEA installation.
REMOVE
ADHESIVE BACKING
FROM BEAD
USE THE CABLE GUIDES TO HOLD THE CABLE IN POSITION
UNTIL IT REACHES THE INNER TRIM OR MOULDING
figure 30
figure 30
figure 31
figure 31
[
]

Installation

Advertisement

Table of Contents
loading

Table of Contents