Sirius Satellite Radio SIRIUS STILETTO 2 Installation & User Manual page 35

Step 2: Prepare the FEA for temporary installation
Attach the suction cups to the antenna portion of the FEA in the positions shown in Figure
20. The antenna portion of the FEA is the relatively thinner section of the cable in between the
bead and the arrow, and transmits the FM signal to your vehicle's FM antenna.
ATTACH SUCTION CUPS AS SHOWN
ARROW
ON BOTH ENDS OF THE THIN WIRE
THIS THINNER PORTION OF THE FEA IS
WHAT TRANSMITS THE FM SIGNAL TO
YOUR VEHICLE'S FM ANTENNA
Step 3: Temporarily install the FEA using the suction cups
for your vehicle's antenna type
On the next several pages you will find the FEA mounting location for your type of FM antenna
(a, b, C, etc.). Before attaching the FEA, clean the area where the suction cups will be mount-
ed with the supplied alcohol swab. The antenna wire between the two suction cups should be
pulled taut and as straight as possible, and should not obstruct the driver's view.
[ ]

Installation
ANTENNA CABLE
BEAD
DURING THE FINAL INSTALLATION USE THE CABLE
GUIDES TO HOLD THE CABLE IN POSITION UNTIL
IT REACHES THE INNER TRIM OR MOULDING
figure 20 figure 20
CONNECTS TO THE FM OUT
CONNECTOR OF YOUR
SIRIUS RADIO OR DOCK