Download Table of Contents Print this page

Mounting The Camera - D-Link DCS-5030L Quick Installation Manual

Hd pan & tilt wi-fi day/night camera
Hide thumbs Also See for DCS-5030L:

Advertisement

Available languages
Table of Contents

mOUNTING THE CAmErA

Please refer to the steps below to assist you with mounting the camera using the arm mount. We
suggest that you configure the camera before mounting.
DCS-5030l
Step 1:
Place the arm mount where you want to position the camera and
use a pencil to mark the holes. Ensure the arm mount is oriented
correctly with adequate space for the camera to be mounted and
necessary cables to be routed.
Step 2:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep with a 6mm drill bit where you marked.
After drilling the holes, insert the plastic anchors to support the
screws.
Step 3:
If desired, the cable can be concealed behind the mounting bracket.
Run the cable through the back of the mounting bracket, securing
it with the built-in guides. Be sure to leave enough cable length
protruding to allow connection to the camera.
Step 4:
Fasten the mounting bracket to the wall using the screws provided.
Step 5:
Using the supplied thumbscrew, fasten the camera to the mounting
bracket. Connect the power cable to the camera.
Step 6:
Adjust the angle of the arm on the mounting bracket as required.
Tighten the thumbscrew to lock the arm in place.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents