Mounting The Camera - D-Link DCS-942L Quick Installation Manual

mOUNTING ThE CAmErA

please refer to the steps below to assist you with mounting the camera. It is recommended that you
configure the camera before mounting.
1
2
3
4
5
6
4
Step 1:
the camera needs to be removed to expose the holes in the
mounting base. unscrew the camera head from the mounting base
by turning counterclockwise.
Step 2:
use a flathead screwdriver to remove the base cover from the
mounting base. place the mounting base where you want to position
the camera and use a pencil to mark the holes.
Step 3:
depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep with a 6mm drill bit where you marked. If
the wall is made out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
Step 4:
place the mounting base over the holes that are in the wall. make
sure to align the mounting base holes with the holes in the wall. use
the supplied screws to attach the mounting base to the surface of
the wall.
Step 5:
place the base cover on the base. make sure to align the base
cover notch with the mounting base for future removal. afterwards,
reattach the camera head onto the mounting base.
Step 6:
adjust the angle of the camera as desired, then tighten the collar on
the camera stem to lock it in place.
dcs-942l