Mounting The Camera - D-Link DCS-936L Quick Installation Manual

mOUNTING THE CAmErA

Please refer to the steps below to assist you with mounting the camera. It is
recommended that you configure the camera before mounting.
1
2
3
4
5
6
4
Step 1:
Hold the base of the camera with one hand placing
your thumb on the tab, then press down on the
release buttons with your other hand and pull the
camera from the camera base.
Step 2:
Place the camera base where you want to position
the camera and use a pencil to mark the holes. Make
sure that the cable channel on the camera base is
facing in the direction you want.
Step 3:
Depending on the material of the wall or ceiling, use
proper tools to drill two holes 25mm deep with a 6mm
drill bit where you marked. If the wall is made out of
concrete, drill the holes first, then insert the plastic
anchors to support the screws.
Step 4:
Pull the power cable through the middle of the
camera base and through the cable channel as
shown.
Step 5:
Place the camera base over the holes that are in
the wall. Make sure to align the camera base holes
with the holes in the wall. Use the supplied screws to
attach the camera base to the surface of the wall.
Step 6:
Attach the camera to the camera base and pull the
power cable to remove the extra cable. Adjust the
angle of the camera as desired.
DCS-936L