Table of Contents
Advertisement
After entered "Network" interface, select "Advanced" interface as below. Then select "UPNP".
Click "Setup" button to go to "UPNP" setting interface as below.
UPNP is Universal Plug and Play. With UPNP function, it will no need to set port mapping in router.
All port mapping has been done by DVR firmware.
17.1 UPNP setting steps
(1) Set your network segment of DVR with the same with router's. Recommend you use the
DHCP function. Then manually enable UPNP in your router.
(2) Enable "UPNP" function in the interface in page 62.
(3) Click "Add" button. Input the "Service Name". It can be whatever you want. Select the right
protocol TCP/UDP. "DVR Port" and "Router Port" can be the same with each other.
(4) You can check the UPNP setting list in your router. (Some router maybe don't have the
UPNP setting list).
(5) You can check if the UPNP setting is correct by accessing DVR from web. Input "http://IP:Port"
in web browser address. "IP" is DVR WAN IP. "Port" is DVR http port.
18. Cloud Service:
Advertisement
Table of Contents
