Table of Contents
Advertisement
12. Record Setup
Record setting menu as right picture:
Before using the record function, it is important to set the record parameters. It is related to video
playback and hard disk capacity, etc. After login, select "Record Setup" -> "Record Parameter"
•
Channel No.: Customer can select the channel by pressing "+", "-" on remote controller
or by the mouse.
•
Record type: The record parameters will be active in the selected record mode.
•
Encoding stream type: VBR and CBR.
VBR: It means when compress the video signal, system can adjust the compression bite
rate dynamically, thus when recording, system maximally saves HDD
CBR: The compression bit rate keeps constant even when image source changes. The characteristic
for CBR is in limited bitrate to have good compression images, as well as easy to estimate the HDD
occupation and network bandwidth.
•
Definition:720p/FD1/CIF (960H/Q960H).
•
Video quality: There are 6 levels of video quality. (highest, higher, high, middle, low,
and lowest)
•
Frame rate: 2-25/30 fps. (720p)
•
Bitrate: Compression bit rate upper limit. They are: 720P is 2M, 3M, 4M, 6M, User define
•
adjustable, under 960H/FD1 is 512K, 768K, 1M, 1.5M, 2M, 3M, 4M, User define adjustable.
•
Audio: Tick off indicates open, otherwise means off.
•
Pre-record time: The 4 record modes support Pre-record function, default pre-record time
is 10s, range is 5-30s.
•
Delay record time: The record duration time when the motion/sensor alarm appears,
default duration time is 30s, range is 0-180s.
•
If other channel setting are the same, click "Copy" button to enter copy interface, then select
the channel which want copy. Click "Save" button.
Advertisement
Table of Contents
