TANACOM BULL 750 Operating Manual page 25

Functional setting operation
Pickup speed preference
1.
Press MODE BUTTON.
If the display is at
or press RESET BUTTON
right.
2.
Press MODE BUTTON
This display is the pickup setting display.
(Pre-set value is 15.)
3.
Set speed with the power lever.
The output is set as the pre-set value of the power lever. (After
pre-setting, it memorizes the value of the last change.)
-The winding stops when you press the
winding up with the power lever.
While the power lever is at MAX position,
pressing the
motor run at the pre-set pickup speed.
Use
4.
Press the MODE BUTTON
1.While the PICKUP
displayed.
Attention
(5. Pickup speed setting)
display, then move the power lever
to show the display shown on the
again.
PICKUP BUTTON
PICKUP BUTTON makes the
to go back to depth readout.
PICKUP BUTTON
1
2
while
3
OFF
4
is in use for winding, winding speed is not
23
MAX
(the figure corresponds
to the case of setting to 5)