Event Settings - D-Link DNR-312L User Manual

Section 4 - Configuration
This page lets you configure what to do when an event is triggered by a
camera, such as when motion is detected. The NVR can then perform an
action, such as sending an e-mail notification.
For Camera Event Settings and System Event Settings:
Step 1: Select an event to listen for:
Connection Alert is sent when connection is lost.
Lost:
Motion Alert is sent when motion is detected.
Detected:
Digital Input: Alert is sent when the signal voltage is above or below a specific
threshold.
Hard Disk When the Overwrite function is not enabled, the NVR will stop
Space Full: recording when the HDD is full and will send an alert.
Hard Disk An alert will be sent if there is an error with the hard disk.
Error:
Fan Error: An alert will be sent if there is a fan error.
Network The NVR is disconnected from its network.
Diconnected:
Step 2: Select an event action:
Buzzer:
Buzzer will go off as an alert.
E-Map:
Select this option to update the camera status on the E-Map.
E-Mail:
Select this option to have e-mail sent to a specified SMTP account
after receiving a camera event.
D-Link DNR-312L User Manual

Event Settings

51