Storage - Triumph Tiger 800 Owner's Handbook Manual

STORAGE

Preparation for Storage
Clean and dry the entire vehicle thoroughly.
Fill the fuel tank with the correct grade of
unleaded fuel and add a fuel stabiliser (if
available), following the
manufacturer's instructions.
Warning
Petrol is extremely flammable and can be
explosive under certain conditions. Turn
the ignition switch off. Do not smoke.
Make sure the area is well ventilated and
free from any source of flame or sparks;
this includes any appliance with a pilot
light.
Remove the spark plug from each cylinder
and put several drops (5 ml) of engine oil into
each cylinder. Cover the spark plug holes
with a piece of cloth or rag. With the engine
stop switch in the RUN position, push the
starter button for a few seconds to coat the
cylinder walls with oil. Install the spark plugs,
tightening to 12 Nm.
Change the engine oil and filter (see
page 78).
Check and if necessary correct the tyre
pressures (see page 127).
Set the motorcycle on a stand so that both
wheels are raised off the ground. (If this
cannot be done, put boards under the front
and rear wheels to keep dampness away
from the tyres.)
Spray rust inhibiting oil (there are a host of
products on the market and your dealer will
be able to offer you local advice) on all
unpainted metal surfaces to prevent rusting.
Prevent oil from getting on rubber parts,
fuel stabiliser
brake discs or in the brake calipers.
Lubricate and if necessary adjust the drive
chain (see page 87).
Make sure the cooling system is filled with a
50% mixture
HD4X Hybrid OAT coolant, as supplied by
Triumph, is pre-mixed and requires no
dilution) and distilled water solution (see
page 80).
Remove the battery, and store it where it will
not be exposed to direct sunlight, moisture,
or freezing temperatures. During storage it
should be given a slow charge (one ampere
or less) about once every two weeks (see
page 105).
Store the motorcycle in a cool, dry area, away
from sunlight, and with a minimum daily
temperature variation.
Put a suitable porous cover over the
motorcycle to keep dust and dirt from
collecting on it. Avoid using plastic or similar
non-breathable, coated materials that restrict
air flow and allow heat and moisture to
accumulate.
Storage
of coolant (noting that
121