Page 1
Operation Manual Read Before Using Intended Use The iReliev Pain Relief Patch is intended for temporary relief of pain associated with sore and aching muscles in the upper and lower extremities (arm and/or leg) due to strain from exercise or normal household...
Cleaning and Maintenance …………………..…… Warnings & Precautions ……………………………..3 Device Contraindications & Adverse Reactions …………... 6 Electrode Introduction to iReliev Pain Relief Patch ………..Placement of Electrode …………………………..Components and Functional Parts of the Unit Troubleshooting Guide …………………………..Prior to Use...
Read instruction manual before operation. Be sure to comply with all “CAUTIONS” and “WARNINGS” in the manual. Failure to follow instructions can cause harm to user or device. Please read the following information carefully before using the iReliev Pain Relief Patch. Contraindications: Do not use this Device if any of the following conditions are present.
Page 4
Do not use these devices in or close to water. Use the Pain Relief Patch only on normal, healthy, clean and dry skin. Do not use it on open wounds or rashes, or over swollen, red, infected or inflamed skin.
Page 5
Do not solely rely on the treatment of this device for pain. The safety of using the Pain Relief Patch during pregnancy or birth has not been established. The effectiveness of this device depends greatly on a person’s individual physical condition. It may not always be effective for every user.
Use Caution and consult your Physician before using the Pain Relief Patch if any of the following conditions apply to you: If you have suspected or diagnosed heart problem. If you have suspected or diagnosed epilepsy. If you have a tendency to bleed internally following an injury.
(LED Green) Back side battery compartment The iReliev Pain Relief Patch, Model No. ET-0303, is intended for temporary relief of pain associated with sore and aching muscles in Electrode pad the upper and lower extremities (arm and/or leg) due to strain from...
After checking, press the DOWN/OFF button to switch the unit off. 2.2 Position the iReliev Pain Patch device and electrode pad so that the plugs and jacks are aligned on a flat surface. Then press down until electrode pad is completely snapped in.
3. Installing/Changing the Battery 4. Use and Functions 4.1 Familiarize yourself with the safety notes, and then proceed as described in section 1~3. 4.2 Place electrode pad on the area of skin selected and press it down with firm pressure. 4.3 Switch the device on by pressing ON/UP button.
5. After Use 5.1 The adhesiveness of Electrode is very high when first used and care should be taken when removing the complete unit especially the first time. 5.2 Remove the pad form the skin by taking the electrode pad at the edge and pulling carefully. Do not grasp at the unit. Replace the electrode pad onto the clear plastic shield.
Device may be cleaned with slightly moistened cloth while ensuring that water Be sure to use only iReliev Patch Pads Refill Kit or Electrode Pads does pentrate device. Do not immerse. Do not use the device again until it is Model No.
Troubleshooting Guide PROBLEM CAUSE REMEDY No battery in the device or battery is dead Replace battery Battery not inserted correctly Insert Battery again (+ up) Switch device on Led fails to light up Device not switched on Remove insulating film from between battery Insulating film has not be removed and the device Led lights up weakly...
Limited One (1) Year Warranty This iReliev Pain Relief Patch carries a one-year warranty from the date of purchase. The warranty applies to the main device and necessary parts and labor relating thereto. Battery, electrodes, and other accessories are warranted to be free from defects in workmanship and materials at the time of delivery.
Need help?
Do you have a question about the Pain Relief Patch and is the answer not in the manual?
Questions and answers