Service Programmes - Siemens TI 905 Series User Manual

en Service programmes
.

Service programmes

Every so often – the exact frequency
S e r v i c e p r o g r a m m e s
depends on usage and water hardness
– one of the following messages will
appear in the display in place of the
coffee selection:
Rinse milk system
■
Run descaling program urgently!
■
Run cleaning program urgently!
■
Run calc'nClean program urgently!
■
The appliance should immediately be
cleaned or descaled using the
appropriate programme. Alternatively,
the two processes Descale and Clean
can be carried out together using the
calc'nClean function. Failure to carry out
the service programme according to the
instructions may damage the appliance.
You can also start the service
programmes at any time without having
to wait for a reminder to appear in the
display. Press the $/± button, select the
desired programme and run it.
Notes
Important: If the appliance is not
■
descaled in good time, the message
"Descaling required, appliance will
shortly be locked" will appear.
Immediately perform the descaling
process in accordance with the
instructions. If the appliance is
locked, it can only be operated
again once the descaling process
has been carried out.
Do not drink the liquids.
■
Never use vinegar, vinegar-based
■
products, citric acid or citric
acid-based products for descaling.
For cleaning and descaling only use
■
the tablets intended for such. The
tablets were specially developed for
this appliance and new stocks can
be ordered through customer
service. ~ "Accessories"
on page 11
30
Never insert descaling tablets or
■
other media into the grounds
compartment.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Rinse the
milk system.
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion to
form.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
If one of the service programs is
■
interrupted, e.g. by a power outage,
proceed as follows:
Rinse out the water tank.
1.
Pour in fresh still water up to the
2.
"max" marking and confirm.
The programme starts and rinses the
appliance. Duration: approx.
2 minutes.
Empty, clean and re-insert the drip
3.
tray.
Empty, clean and re-insert the milk
4.
container.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
5.
programme.