Troubleshooting; Scanner - Panasonic KX-PS8000 Operating Instructions Manual

Care and Maintenance

Troubleshooting

114

Scanner

Trouble
Scanner does not turn
on.
Scanner Error 49 is
displayed on LCD when
powered on.
Scanning operation can-
not be performed.
Scanned image is dirty.
ABCD - - - - -
- - - - - - - - - -
- - - - - - - - - -
- - - - - -
One or both ends of
image is/are not
scanned.
Scanned image is blurred
or partially colored.
Scan quality is bad.
ADF doesn't feed
document.
Possible Cause
AC cord is not
connected.
Scanner is locked.
SCSI cable is not
properly connected.
SCSI ID No. is not set
correctly.
SCSI-2 board is not
compatible.
Software may not be
installed.
Original document is dirty.
Scanner glass is dirty.
Document is not
positioned correctly.
Document is not evenly
set on the scanner glass.
You may not be using the
software utility correctly.
Condensation has
occurred.
Document thickness is
out of specifications.
Too many documents are
inserted in the ADF tray.
Corrective Action
Connect the AC cord.
Unlock the scanner
( P. 30).
Connect the SCSI cable
( P. 44-50).
Set the SCSI ID No.
correctly ( P. 52).
Use a recommended
SCSI-2 board ( P. 16).
Install the software
( P. 55).
Clean the document.
Clean the scanner glass.
Reposition the document
correctly according to the
size.
Set the document evenly.
Consult the Utilities and
Drivers Reference
manual.
Leave the unit for 4 or 5
hours.
Scan the document by
placing it on the scanner
glass.
The height of document
should not exceed the
limit mark on the
document guide.