Dcis Stand Alone System - Panasonic KX-PS8000 Operating Instructions Manual

Setup
46

DCIS Stand Alone System

1
Make sure the scanner and printer are turned off.
2
Connect the SCSI cable provided to the scanner's SCSI
connector A or B and to the printer's SCSI connector.
3
Make sure the terminator switches (#4) of the scanner and printer
are set to ON.
1 2
ON
Scanner
BTo change a terminator setting, refer to
4 Connect the power cord to the scanner's AC inlet and to an AC
outlet.
5
Connect the other power cord to the printer's AC inlet and to an
AC outlet.
3 4
Printer
page 52.