Advertisement
R11222
BHA24K - DW004K - DW005K Cordless 24 volt Rotary Hammer
Use only genuine grease (800) 870889-49 to maintain performance and reliability, it has been specially
developed for these units. The unit is lubricated with approximately 60gms of grease.
A special assembly grease (802) should be used when re-assembling these units, especially around the
spindle (149), main gear (167) and Intershaft (171). A generous smear should be applied around all mating
surfaces.
The tool bit grease (801) is available in a 100 gm tube under part number 328771-03.
Ensure the needle rollers on axial bearing (172) face towards washer (173) and the smooth side interfaces
with intergear (171)
Ensure the notches on the field magnet (102) are orientated correctly on re-assembly. If not correct, then
the unit could run in reverse.
Items (124 & 125) battery retainer latches are left and right hand orientated and cannot be swapped over.
Static control precautions must be taken when handling the switch
R11222EN.rtf
Advertisement
