Saeco HD8763 Operating Instructions Manual page 79

Machine actions
The machine does not turn on.
The drip tray gets fi lled al-
though no water is drained.
The red icon is always dis-
played on the machine.
Coff ee is not hot enough.
Coff ee does not have enough
crema.
(See note)
The machine takes a long time
to warm up or the amount of
water dispensed is too little.
The brew group cannot be
removed.
The brew group cannot be
inserted.
Causes
The machine is not connected to the
electric network, or the power but-
ton is in the "O" position.
Sometimes water is drained auto-
matically by the machine into the
drip tray to manage the rinsing of
the circuits and ensure optimum
machine performance.
The coff ee grounds drawer has been
emptied with the machine off .
The cups are cold.
Temperature is not correctly set.
The machine circuit is clogged by
limescale.
The blend is unsuitable, coff ee is not
freshly roasted or the grind is too
coarse.
The machine circuit is clogged by
limescale.
The brew group is not in the right
position.
The coff ee grounds drawer is
inserted.
The brew group is not in the off
position.
The gearbox is not in the correct
position.
ENGLISH
Solutions
Connect the machine to the electric
network and turn the power button to
the "I" position.
This is a normal behaviour of the
machine.
The coff ee grounds drawer must al-
ways be emptied with the machine on.
Wait until the icon is displayed
before refi tting the drawer.
Preheat the cups with hot water.
Set the temperature as described in the
"Programming" chapter.
Descale the machine.
Change coff ee blend or adjust the
grind setting as explained in the
"Adjusting the Ceramic Coff ee Grinder"
chapter.
Descale the machine.
Turn on the machine. Close the service
door. The brew group automatically
returns to the initial position.
Remove the coff ee grounds drawer
before removing the brew group.
Make sure that the brew group in
the off position, as described in the
"Weekly Cleaning of the Brew Group"
chapter.
Insert the drip tray and the coff ee
grounds drawer. Close the service door.
Turn on the machine without inserting
the brew group. The gearbox returns
to the correct position. Turn off the
machine and reinsert the brew group
as described in the "Weekly Cleaning of
the Brew Group" chapter.
77 77