Table of Contents
Advertisement
5
Installation of the DRM-ULV16
4
Preparation for installation
1
Unpack the CONV unit block. Set aside the LVD connector
guard Assy.
2
Attach the two supplied card spacers.
CONV unit block
3
Temporarily install the CONV unit block in the changer in order
to check if it interferes with the card spacer or not.
CONV unit block
4
Check the position of the flat cable clamp and determine
the location where the cushion is to be adhered.
A) In a case where the flat cable clamp is located at the right
of the right card spacer and does not get in the way of it
CONV unit block
Card spacer
Remove the temporarily installed CONV unit block.
(Leave the flat cable clamp in place.)
5
Adhere the supplied cushion.
5
Cushion
Reference line
(left side of the flat cable clamp)
5
6
1
LVD connector guard Assy
Before attachment
After attachment
Flat cable clamp
Flat cable clamp
DRM-ULV16
6
7
2
Card spacer
2
Card spacer
CONV unit block
Bottom view
a
a
b
b
B) In a case where the flat cable clamp is located at the left of
the right card spacer or gets in the way of it
CONV unit block
Flat cable clamp
Remove the temporarily installed CONV unit block
then remove the flat cable clamp.
5
Cushion
(right side of the engraved mark)
7
8
Install the CONV unit block so that the
protruding screws a are inserted
through the elliptical holes b (
Card spacer
Engraved mark
Reference line
8
A
B
C
).
D
E
F
19
Advertisement
Table of Contents
