7.2 OPERATION CHECKS
Note: Be sure to perform the following operation checks after installation or repair.
7 Things required for operation checks
• GGS1030: DiagnoseV (use the version 2.900 or later)
• GGV1035: DVD-ROM (Single/DVDT-001)
• Personal computer
∗: SCSI data must be checked via the DRM-ULV16, as shown in Fig.1 "Connection example" below.
∗: On the DVD-D7563 or DVD-D7362, the SCSI mode must be set to SCSI-3, as shown in Fig.2.
When the SCSI mode setting was changed, return the switch setting to the original after checking.
Fig.1: Connection example
Fig.2: Function switches
These switches are used for inspection before shipment. Do NOT change the settings.
SCSI mode select switch
OFF (SCSI-2 mode): Burst transfer rate 10 MByte/sec
ON (SCSI-3 mode): Burst transfer rate 20 MByte/sec
∗: Upon shipment, the switch is set to OFF (SCSI-2 mode).