Wrist Strap - Hasselblad Winder CW Instruction Manual

remain at 'C', but if several exposures are required, the mode switch
must be set at 'M' again so that the process can be repeated.
rc = r c
eMote
For use with the Hasselblad IR Remote Control only. In this position
the winder's modes are selected by way of the IR Remote Control unit
and the manual release button on the winder becomes inoperative. As
much more current is required in the 'RC' mode compared to the other
modes, the winder should be switched back to the 'L' mode when not in
use to conserve the batteries.

Failure to switch back to the 'L' mode, preferably, or any
mode other than 'RC' after use can drain the batteries
completely in a matter of days.

Wrist strap

The wrist strap (3044118) - (supplied) - is attached to the upper and
lower strap lugs in a similar manner to the camera strap (see camera
instructional manual for details of securing clip attachment and
removal). The slightly angled securing clip should be attached to the
upper strap lug.
Hasselblad IR remote control
The IR Remote control (3044113) –supplied– is very compact and pro-
vides not only wireless remote release but also the capability of remote
mode choice. That is to say, any one of the three winder modes (S, C and
M) can be both chosen and changed without having to return to the
camera position.
Additionally, the IR Remote control will only activate the winder, or
winders, that have been programmed together with it. Therefore any
other camera/winder combination will remain inactivated by that
particular remote control until programmed to do so. This means that
several winders can be independently remotely controlled by their own
individual controls without controlling other winders unintentionally
as the signal from each control is unique.
8
ontroL
Accessories
7
8