Husqvarna 265 ACX Operator's Manual page 27

Laying the boundary wire in towards the charging
station
The boundary wire can be routed in several different
ways in towards the charging station. The best
alternative is to route the wire completely outside the
charging station, see alternative 1. The wire can also
be placed under the charging station plate as shown
in alternative 2 in the illustration. However, the wire
should not be placed outside alternative 2 because it
can then be difficult for Automower
charging station.
When connecting to the charging station, the right
end of the boundary wire should be guided into the
right-hand hole and the cable's left end in the
left-hand hole.
Joining the boundary wire
If the boundary wire is not long enough and needs to If the boundary wire is not long enough and needs to If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler. It is be spliced: Use original solderless coupler. It is be spliced: Use original solderless coupler. It is
waterproof and gives a reliable electrical connection. waterproof and gives a reliable electrical connection. waterproof and gives a reliable electrical connection.
Insert both wire ends in the coupler. Make sure the Insert both wire ends in the coupler. Make sure the Insert both wire ends in the coupler. Make sure the
wires are fully inserted in the coupler by checking that wires are fully inserted in the coupler by checking that wires are fully inserted in the coupler by checking that
the wire ends are visible through the transparent area the wire ends are visible through the transparent area the wire ends are visible through the transparent area
on the other side of the coupler. Now press down the on the other side of the coupler. Now press down the on the other side of the coupler. Now press down the
button on top of the coupler fully. Use a pair of pliers button on top of the coupler fully. Use a pair of pliers button on top of the coupler fully. Use a pair of pliers
if the button on the coupler is difficult to press down if the button on the coupler is difficult to press down if the button on the coupler is difficult to press down
by hand.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.
3. INSTALLATION
® to find the
1.
2.
English - 29