Alignment
TX Power Adjustment (Low Power)
Connect the wattmeter and dummy load to the an-
tenna jack.
Set the transceiver to CH16 (156.800 MHz) with "Low"
power mode, then turn the transceiver off.
Press and hold in the PTT, [ SQL ] , [ ] , and [ ] keys
while turn the transceiver on to enter the alignment
mode.
Press the [ ] or [ ] key to select
L Po xx
L Po xx
the display to "L Po xx
L Po xx
L Po xx"
Press the [ CLR/WX ] key to enable
adjustment of this Alignment
Mode.
Press the PTT key to transmit the transceiver, if nec-
essary, press the [ ] or [ ] key to adjust the output
power to 0.8 W (±0.05 W).
Press the [ CLR/WX ] key to save the new setting.
Press and hold the [ POWER ( )] key for 2 seconds to
turn the transceiver off.
Tx Deviation Adjustment
Connect the Radio Tester to the Mic jack, then adjust
the Audio generator output to 50 mVrms at 1 kHz.
Set the transceiver to CH16 (156.800 MHz) with "Low"
power mode, then turn the transceiver off.
Press and hold in the PTT, [ SQL ] , [ ] , and [ ] keys
while turn the transceiver on to enter the alignment
mode.
Press the [ ] or [ ] key to select
nod xx
nod xx".
nod xx
the display to "nod xx
nod xx
Press the [ CLR/WX ] key to enable
adjustment of this Alignment
Mode.
Press the PTT key to transmit the transceiver, if nec-
essary, press the [ ] or [ ] key to adjust the devia-
tion to 4.2 kHz (±0.1 kHz).
Press the [ CLR/WX ] key to save the new setting.
Press and hold the [ POWER ( )] key for 2 seconds to
turn the transceiver off.
The Alignment is now completely.
12