Black & Decker GL741 User Manual page 5

Store idle tools
When not in use, tools should be stored in a dry,
locked up or high place, out of reach of children.
Maintain tools with care
Keep cutting tools sharp and clean for better and
safer performance. Follow the instructions for
maintenance and changing accessories. Keep
handles and switches dry, clean and free from oil
and grease.
Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried out
by qualifi ed persons using original spare parts;
otherwise this may result in considerable danger to
the user.
Electrical safety
This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
• This appliance is not intended for use by young
or infi rm persons without supervision. Children
must be supervised to ensure they do not play
with the appliance.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.
Additional safety instructions for grass
trimmers
The following warning symbols are found on the
tool:
Read the manual prior to operation.
Wear safety glasses or goggles when
operating this tool.
Keep people and animals at least 6 m
away from the cutting area.
Do not expose the tool to rain or high
humidity.
• Be familiar with the controls and the proper use
of the equipment.
• Only use the machine in daylight or good
artifi cial light.
• Before use check the supply and extension
cord for any signs of damage or ageing.
If the cord becomes damaged during
use, disconnect the cord from the supply
immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY
• Do not use the lawn trimmer (edge trimmer), if
the cords are damaged or worn.
• Wear stout shoes or boots to protect your feet.
• Wear long trousers to protect your legs.
• Before using the tool, check that your cutting
path is free from sticks, stones, wire and any
other obstacles.
• Only use the tool in the upright position, with
the cutting line near the ground. Never switch
the tool on in any other position.
• Move slowly when using the tool. Be aware
that freshly cut grass is damp and slippery.
• Do not work on steep slopes. Work across the
face of slopes, not up and down.
• Never cross gravel paths or roads while the
tool is running.
• Never touch the cutting line while the tool is
running.
• Do not put the tool down until the cutting line
has come to a complete standstill.
• Use only the appropriate type of cutting line.
Never use metal cutting line or fi shing line.
• Be careful not to touch the line trimming blade.
• Take care to keep the mains cable away
from the cutting line. Always be aware of the
position of the cable.
• Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor.
• Warning. Cutting elements continue to rotate
after the motor is switched off.
• Never operate the machine with damaged
guards or without the guards in place.
• Always ensure that the ventilation openings
are kept clear of debris.
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Adjustment button
7. Tube
8. Guard
9. Line trimming blade
10. Spool housing
11. Cutting line
12. Edge guide
ENGLISH
5