Shifting; Forward (Tiller Handle And Remote Control Models); Reverse - Outboards Group 2.5A Owner's Manual

Operation
CAUTION:
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out of
the hole at all times while the engine is
running, overheating and serious damage
could occur. Stop the engine and check
whether the cooling water inlet on the low-
er case or the cooling water pilot hole is
blocked. Consult your Outboards dealer if
the problem cannot be located and cor-
rected.

Shifting

WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
CAUTION:
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the en-
gine idles (or runs at low speeds).
17
Forward (tiller handle and remote con-
trol models)
Tiller handle models
1. Place the throttle grip in the fully closed
position.
2. Move the gear shift lever quickly and firm-
ly from neutral to forward.
Remote control models
Pull up the neutral interlock trigger (if
equipped) and move the remote control lever
quickly and firmly from neutral to forward.

Reverse

WARNING
When operating in reverse, go slowly. Do
not open the throttle more than half. Other-
wise the boat could become unstable,
which could result in loss of control and
an accident.