Operation
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to "
10 seconds, then crank the engine
again.
Warming up engine
Choke start models
1.
After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life. Gradually re-
turn the choke knob to its home position
as the engine warms up.
2.
Check for a steady flow of water from the
cooling water pilot hole.
CAUTION:
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out
of the hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Outboards
dealer if the problem cannot be located
and corrected.
31
" (on), wait
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
CAUTION:
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the
engine idles (or runs at low speeds).
Forward (tiller handle and remote
control models)
Tiller control models
1.
Place the throttle grip in the fully closed
2. Move the gear shift lever quickly and
Shifting
WARNING
position.
firmly from neutral to forward.