Setting The Tv - Sharp LC-46HD1E Operation Manual

Preparation

Setting the TV

Standard DIN45325 plug (IEC
169-2) 75 q coaxial cable
ANT 2
ANT
SAT 2
* Do not disconnect this cable
unless otherwise instructed.
** When making the satellite
connection, make sure that
ANT SAT 1 takes priority, and
do not connect ANT SAT 2
alone.
Cable clamp
(large)
Bundle the
cables with the
clamp.
Antenna
Connect the antenna cable from your antenna-
/cable socket or the (room-/roof) antenna for
antenna input terminal on the back of your TV set to
receive digitally/terrestrially broadcast stations.
An indoor antenna can also be used under good
reception conditions. Passive and active room
antennas are offered commercially. In an active
antenna its power is supplied via the antenna input
terminal.
The supply voltage (5V) must be correspondingly
set under "Allow switching voltage". (Page 35)
* Ferrite Core
The Ferrite Core should be permanently attached
and never removed from the AC cord.
Downloaded From TV-Manual.com Manuals
Connected at
the factory *
ANT SAT 1 **
Cable tie
Place the TV close to the AC outlet, and keep
(For Europe, except U.K.
and Eire)
(For U.K. and Eire)
AC cord
Cable clamp (small)
Setting the TV on the wall
• This TV should be mounted on the wall only with the
wall mount bracket available from SHARP. (Page
59) The use of other wall mount brackets may result
in an unstable installation and may cause serious
injuries.
• When you use the AN-52AG4 (SHARP) wall mount
bracket, set the angle of the TV to 0° or 5°. Do not set
the angle to more than 10°.
• Installing the LCD Colour TV requires special skill
that should only be performed by qualified service
personnel. Customers should not attempt to do the
work themselves. SHARP bears no responsibility
for improper mounting or mounting that results in
accident or injury.
• You can ask a qualified service personnel about using an
optional bracket to mount the TV to the wall.
the power plug within reach.
Ferrite core*
5