Nothing Appears On The External Monitor - Epson EB-L1505U User Manual

Problem Solving
Check
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
Are the remote control ID and the projector ID matched?
Does Remote Control Type match the remote control that you are
using?
Is the optional remote control cable connected to the projector's
Remote port?
Is Control Communications or Extron XTP set to On?
Is the remote control button lock set?

Nothing appears on the external monitor

Check
Are images input from a port other than the Computer port or
BNC port?
Are you projecting a split screen?
Is the projector in standby status?
s "Replacing the remote control batteries"
Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors
by remote control regardless of the ID setting, set the [ID] switch on the remote control to Off.
s "ID Settings" p.40
Check the Remote Control Type on the configuration menu.
s Extended - Operation - Advanced - Remote Control Type
When the remote control cable is connected, the projector's remote receiver is disabled. When not using the remote
control cable set, disconnect it from the Remote port.
The Remote port is disabled. When using the optional remote control cable set, set Control Communications or Extron
XTP to Off.
s Extended - HDBaseT p.133
When the remote control button lock is set, buttons except for those needed for basic remote control operations are
deactivated. Hold down the [ ] button to cancel the remote control button lock.
s "Remote control button lock" p.120
Only RGB signals from the Computer port or the BNC port can be displayed on an external monitor.
Only RGB signals projected on the left screen from the Computer port or the BNC port can be displayed on an
external monitor.
s "Projecting Two Images Simultaneously (Split Screen)"
Check that Standby Mode, A/V Output, and Monitor Out from the Configuration menu are set correctly.
s Extended - Standby Mode, A/V Settings
Remedy
p.23
p.133
Remedy
p.104
p.133
179