Grounding Instructions - KitchenAid Electric 30-inch Installation Instruction

2
Begin the
imtallation
Remove racks and all other contents from oven
before moving appliance. Be
sure
to remove
all
packaging material (cardboard, protective film,
etc.) from range before use.
A. Remove shipping skid
Remove the 4 cardboard pads from shipping box.
Place them on floor as shown to protect appliance's
finish. Rest appliance (on its back) on pads.
Remove the two 3/8" shipping bolts from wooden
skid. Discard the skid.
B. Extend leveling legs
Once skid is removed, 4 leveling legs are exposed at
bottom of frame.
Loosen legs by applying an adjustable wrench to the
1%" base of the leveling legs. Back each of them out
about 4 complete turns.
Stand appliance on its base.
3
Begin electrical
connection
Grounding Instructions
WARNING:
THIS APPLIANCE MUST BE CONNECTED TO A
GROUNDED, METALLIC, PERMANENT WIRING
SYSTEM, OR AN EQUIPMENT GROUNDING
CONDUCTOR SHOULD BE RUN WITH THE
CIRCUIT CONDUCTORS AND CONNECTED TO
THE EQUIPMENT GROUNDING TERMINAL OR
LEAD ON THE APPLIANCE.
WARNING:
To prevent electrical shock hazard, disconnect
power at fuse box or circuit breaker before
connecting flexible armored cable for
permanent wiring.
A. Remove tetminaf
block cover
W' brass nuts
Retaining screws
Terminal block is located on back of the appliance
near the bottom.
Remove retaining screws to expose electrical
terminal block.
USE ONLY the supplied 3/~" brass nuts when
connecting cord.
USE ONLY ring type terminals to connect cord.
4