Coaxial Line Protection; Telephone Line Protection; Ac Power Cord - Panamax MAX 5410 Owner's Manual

FEATURE DETAILS
UTLETS SATELLITE CATV/ANT
USB
LED
LIGHT
RS232 CONTROL
Engineered
in the USA
Assembled
in China
12V TRIGGER
HC SWITCHED LINE EQUIP. 1 EQUIP. 2
IN OUT
TRIGGER TRIGGER OUTLETS OUTLETS
ENABLE DELAY DELAY DELAY
UTLETS SATELLITE CATV/ANT
USB
LED
LIGHT
RS232 CONTROL
Engineered
in the USA
Assembled
in China
12V TRIGGER
HC SWITCHED LINE EQUIP. 1 EQUIP. 2
IN OUT
TRIGGER TRIGGER OUTLETS OUTLETS
ENABLE DELAY DELAY DELAY
UTLETS SATELLITE CATV/ANT
USB
LED
RS232 CONTROL LIGHT
Engineered
in the USA
Assembled
in China
12V TRIGGER
IN OUT HC SWITCHED LINE EQUIP. 1 EQUIP. 2
TRIGGER TRIGGER OUTLETS OUTLETS
ENABLE DELAY DELAY DELAY
UTLETS SATELLITE CATV/ANT
USB
LED
LIGHT
RS232 CONTROL
Engineered
in the USA
Assembled
in China
12V TRIGGER
HC SWITCHED LINE EQUIP. 1 EQUIP. 2
IN OUT
TRIGGER TRIGGER OUTLETS OUTLETS
ENABLE DELAY DELAY DELAY
HIGH CURRENT OUTLETS SWITCHED OUTLETS ALW
15A BREAKER
GROUND
IEC320 INLET
USA & Canada (800) 472-5555 • (707) 283-5900 • Fax (707) 283-5901
™
SignalPerfect

Coaxial Line Protection

All coaxial cable sheaths from outdoors must be grounded to the building grounding electrode system
where they enter the building (per applicable NEC/CEC code). A driven ground rod is not adequate.
Panamax's exclusive SignalPerfect™ Technology provides application-specific protection for your satellite and cable TV
equipment. Two lines of protection are provided for each type. The satellite connections are for coaxial cables connected to
a DBS (single or dual LNB) satellite dish. The antenna connection is for a non-amplified rooftop antenna or cable TV line.
The Additional TV connection protects the equipment plugged into the MAX
where the video signal runs to another room for a downline TV.
Cable TV (Including HDTV) – TV tuners operate at approximately 10 millivolts (0.01 V) and utilize the frequency spec-
trum of 50Mhz to 950Mhz. The clamping level of the MAX
That's less than 1 volt above normal operating levels. The circuitry is shielded to prevent interference and has been opti-
mized to have less than 1dB of signal loss throughout the entire 50Mhz to 950Mhz range.
Satellite - Satellite dish LNB's can require up to 24 volts to operate and utilize the frequency range of 950Mhz to 2.2Ghz.
The clamping level of the MAX
voltage. The circuitry is shielded to prevent interference and has been optimized to have less than 1dB of signal loss
throughout the entire 950Mhz to 2.2Ghz range.
SignalPerfect

Telephone Line Protection

™
Satellite TV receivers require a telephone line connection for Pay-Per-View services. The MAX
protection for this line. The circuitry utilizes auto-resetting PTCRs and solid-state SIDACtors™ for reliability and unsur-
passed protection. The clamping level of the MAX
voltage (90-130VAC) and operating battery voltage (-48DC) to pass through the circuit and still protect the modem in your
satellite receiver from damage.
RJ-11 phone jacks are provided for this protection. A built-in line splitter allows 2 separate components to be connected to
the same phone lines.
Please note: The protection circuitry will not work if the phone lines are reversed. The incoming phone cable must be
connected to the "LINE" jack and the cable to the audio/video equipment must be connected to the "EQUIP" jack.
Power Cord
The MAX 5410 comes equipped with a UL recognized, 10 foot, IEC320 power cord rated for 120V, 15-Amps, minimum 14
®
gauge wire and the cord secured to the enclosure with a cord retention bracket. The cord is not intended to be removed.
5410's cable TV protection circuitry is 700 millivolts (0.7 volts).
®
5410's satellite protection circuitry is 27 volts - just 3 volts above the maximum operating
®
5410's telephone protector is 260 volts. This will allow typical ring
®
5410 from "backdoor" surges in situations
®
5410 also provides surge
®
9