Connect The Surround Back Or Front Height Speakers - Pioneer VSX-820-S/-K Operating Instructions Manual

Connecting your equipment
Bare wire connections
A-Speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
1 2
10 mm
B-Speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1 2
10 mm
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
Connect the surround back or front
height speakers
Connect the PRE OUT outputs of the unit and
additional amplifier to add a surround back or
front height speaker.
• If the surround back speaker or the front
3
Surround back or
front height speakers
SBL/FHL SBR/FHR
3
• You can use the additional amplifier on the
height speaker is connected, set the Pre
Out setting (see The Pre Out Setting on
page 47).
IN BD SUBWOOFER
PRE OUT
SURR BACK /
FRONT
DVD
HEIGHT
L
( Single )
R
PRE OUT
TV/SAT
L
IN
COAXIAL ASSIGNABLE
DVR/VCR
IN 1
R
( CD )
OPTICAL
L
IN 2
OUT
IN
IN 1
R
( CD-R/TAPE )
ASSIGNABLE
HDMI 1 2
surround back channel pre-outs for a
single speaker as well. In this case plug the
amplifier into the left (L (Single)) terminal
only.
Surround back or
front height
channel amplifier
ANALOG
INPUT
L R
CD-R/TAPE DVR/VCR
ADAPTER
( OUTPUT 5 V
1
OUT
CD CD-R/TAPE DVR/VCR
IN M
ANTENNA
FM
UNBAL
DVD BD
TV/SAT 75
IN
AM
LOOP
AUDIO
03
19
En