Connecting To The Front Panel Video Terminal; Plugging In The Receiver - Pioneer VSX-820-S/-K Operating Instructions Manual

03 Connecting your equipment
Connecting to the front panel
video terminal
Front video connections are accessed via the
front panel using the INPUT SELECTOR or
VIDEO button on the remote control. There are
standard audio/video jacks. Hook them up the
same way you made the rear panel
connections.
• Push down on the PUSH OPEN tab to
access the front video connections.
CONTROL ON / OFF
VIDEO INPUT
iPod
iPhone
USB
VIDEO
VIDEO
AUDIO/VIDEO OUTPUT
28
En
MCACC
SETUP MIC
L AUDIO R
This receiver
L
R
Video camera
(etc.)

Plugging in the receiver

Only plug in after you have connected all your
components to this receiver, including the
speakers.
CAUTION
• Handle the power cord by the plug part. Do
not pull out the plug by tugging the cord,
and never touch the power cord when your
hands are wet, as this could cause a short
circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on
the power cord or pinch the cord in any
MASTER
VOLUME
other way. Never make a knot in the cord or
tie it with other cables. The power cords
should be routed so that they are not likely
to be stepped on. A damaged power cord
can cause a fire or give you an electric
shock. Check the power cord once in a
while. If you find it damaged, ask your
nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the
one supplied with this unit.
• Do not use the supplied power cord for any
purpose other than that described below.
• The receiver should be disconnected by
removing the mains plug from the wall
socket when not in regular use, e.g., when
on vacation.
1 Plug the supplied power cord into the AC
IN socket on the back of the receiver.
2 Plug the other end into a power outlet.