Advertisement
A SSE MB LY
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
WARNING
There are several areas during the assembly process of an elliptical that special attention must be paid.
It is very important to follow the assembly instructions correctly and to make sure all parts are firmly
tightened. If the assembly instructions are not followed correctly, the elliptical could have frame parts that
are not tightened and will seem loose and may cause irritating noises. To prevent damage to the elliptical,
the assembly instructions must be reviewed and corrective actions should be taken.
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recommended
that you place a protective covering on your floor. During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded in before completely tightening any ONE bolt.
NOTE
: A light application of grease may aid in the installation of hardware. Any grease, such as
lithium bike grease is recommended.
821E_Rev.1.1.indd 4-5
HANDLE PULSE
BOTTLE HOLDER
CONSOLE MAST
CONSOLE MAST BOOT
PEDAL
ROLLER WHEEL COVERS
GUIDE RAIL
TOOLS INCLUDED
5mm Allen Wrench
4mm Allen Wrench
13/15mm Flat Wrench
17mm Flat Wrench
Phillips Screw Driver
PARTS INCLUDED
1 Main Frame Set
2 Upper Handlerbars
2 Lower Handlerbars
2 Pedal arms
2 Guide Rails
1 Console
1 Console Mast
1 Console Mast Boot
1 Power Supply
1
2
UPPER HANDLEBAR
CONSOLE MAST BOOT
HANDLEBAR COVERS
LOWER HANDLEBAR
HANDLEBAR COVER
STABILIZER TUBE
TRANSPORT WHEEL
PEDAL ARM
2 Crank Boots
2 Front Upper Handlebar Covers
2 Back Upper Handlebar Covers
6 Hardware Pack (contents listed below)
CONSOLE
02/09/09 3:57:03 PM
Advertisement
