Scope Of Use; Assembly And Starting - Stanley B 255/10/50 Instruction Manual

when the temperature is too high. The motor restarts
automatically when normal temperature conditions
are restored.
● To facilitate restart of the compressor, in addition
to the operations indicated, it is important to
return the button of the pressure switch to the
OFF position and then to ON again (fig. 2).
● On single-phase versions, press the reset button on
the terminal box of the motor (fig. 19).
● On 3-phase versions, operate manually on the
button of the pressure switch, returning this to the
ON position, or press the button of the thermal
cutout inside the box of the electric panel (figures
2b & 20).
● The single-phase versions are fitted with a pressure
2. LAYOUT
1. Intake air filter
2. Pressure vessel
3. Wheel
4. Guide roller (or supporting foot)
5. Quick-lock coupling (regulated compressed air)
6. Pressure gauge (for reading the preset tank pres-
sure)
7. Pressure regulator
8. ON/OFF switch
9. Transportation handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the tank pressure)
13. Quick-lock coupling (unregulated compressed air)
14. Oil sealing plug (oil filler opening)
15. Oil drainage screw
16. Oil level window
17. Bolt
18. Nut
19. Washer
20. Check valve

3. SCOPE OF USE

The compressor is designed for generating com-
pressed air for tools operated by compressed air.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used in
commercial, trade or industrial businesses or for equiv-
alent purposes.
The machine is to be used only for its prescribed pur-
pose. Any other use is deemed to be a case of misuse.
switch equipped with a delayed closing air vent valve
(or with a valve located on the check valve) that
facilitates motor start-up; therefore a few-second
jet of air from this, with the reservoir empty, is to be
considered normal.
● To guarantee machine safety, all the compressors
are fitted with a safety valve that is activated in the
case of failure of the pressure switch.
● When fitting a tool, the flow of air in output must be
switched off.
● When using compressed air, you must know and
comply with the safety precautions to be adopted for
each type of application (inflation, pneumatic tools,
painting, washing with water-based detergents only,
etc.).
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused as
a result of this.
4. POINTS TO NOTE WHEN SETTING
UP THE COMPRESSOR
● Examine the machine for signs of transit damage.
Report any damage immediately to the company
which delivered the compressor.
● The compressor should be set up near the working
consumer.
● Avoid long air lines and long supply lines (exten-
sions).
● Make sure the intake air is dry and dust-free.
● Do not set up the compressor in damp or wet
rooms.
● The compressor may only be used in suitable rooms
(with good ventilation and an ambient temperature
from +5°C to +40°C). There must be no dust, acids,
vapors, explosive gases or inflammable gases in the
room.
● The compressor is designed to be used in dry rooms.
It is prohibited to use the compressor in areas where
work is conducted with sprayed water.
● The oil level in the compressor pump has to be
checked before putting the equipment into opera-
tion.

5. ASSEMBLY AND STARTING

Warning!
You must fully assemble the appliance before us-
ing it for the first time.
21
G
B