Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cobalt Digital Inc 9910DA-AV-EQ
Summary of Contents for Cobalt Digital Inc 9910DA-AV-EQ
- Page 1 9910DA-AV-EQ 9910DA-AV-EQ 9910DA-AV-EQ 9910DA-AV-EQ Analog Video Distribution Amplifier with EQ Product Manual Cobalt Digital Inc. 2506 Galen Drive Champaign, IL 61821 Voice 217.344.1243 • Fax 217.344.1245 www.cobaltdigital.com 9910DA-AV-EQ-OM (V1.2)
-
Page 2: Trademark Information
Furthermore, Cobalt Digital Inc. reserves the right to make changes to any products herein to improve readability, function, or design. Cobalt Digital Inc. does not assume any liability arising out of the application or use of any product or circuit described herein. -
Page 3: Table Of Contents
Operating Instructions........Overview ........................ 3-1 Accessing the 9910DA-AV-EQ Card via Remote Control ........3-1 Accessing the 9910DA-AV-EQ Card Using DashBoard™ ....... 3-1 Checking 9910DA-AV-EQ Card Information and Status ........ - Page 4 This page intentionally blank 9910DA-AV-EQ PRODUCT MANUAL 9910DA-AV-EQ-OM (V1.2)
-
Page 5: Chapter 1 Introduction
Chapter 1 Overview This manual provides installation and operating instructions for the 9910DA-AV-EQ Analog Video Distribution Amplifier with EQ card (also referred to herein as the 9910DA-AV-EQ). This manual consists of the following chapters: Chapter 1, “Introduction” – Provides information about this manual •... -
Page 6: Manual Conventions
Manual Conventions Manual Conventions In this manual, display messages and connectors are shown using the exact name shown on the 9910DA-AV-EQ itself (for example, connector names are shown like this: ANLG IN) In this manual, the terms below are applicable as follows: 9910DA-AV-EQ refers to the 9910DA-AV-EQ Analog Video •... -
Page 7: Safety And Regulatory Summary
United States of America FCC "Code of Federal Regulations" Title 47 Part 15, Subpart B, Class A Canada ICES-003 International/CE CISPR 24:2010 IEC 61000-4-2:2008 IEC 61000-4-3:2006 with A1:2007 and A2:2010 IEC 61000-4-4:2004 IEC 61000-4-6:2008 CISPR 22:2008 9910DA-AV-EQ-OM (V1.2) 9910DA-AV-EQ PRODUCT MANUAL... -
Page 8: 9910Da-Av-Eq Functional Description
9910DA-AV-EQ Functional Description 9910DA-AV-EQ Functional Description Figure 1-1 shows a functional block diagram of the 9910DA-AV-EQ. With the appropriate rear module, the 9910DA-AV-EQ can provide up to eight DA analog video outputs and a looping input where desired. 9910DA-AV-EQ Input/Output Formats... - Page 9 Introduction 9910DA-AV-EQ Functional Description Figure 1-1 9910DA-AV-EQ Functional Block Diagram 9910DA-AV-EQ-OM (V1.2) 9910DA-AV-EQ PRODUCT MANUAL...
-
Page 10: Gain Adjust
9910DA-AV-EQ Functional Description Video Clamping Select The card is equipped with clamping select jumpers. Clamping can be set on or off. When set to on, slow and fast clamping can also be selected using another jumper. Slow clamping is stable, while fast clamping is optimized to respond to fast changes in APL where required. -
Page 11: 9910Da-Av-Eq Rear I/O Modules
The 9910DA-AV-EQ physically interfaces to system video connections at the rear of its frame using a Rear I/O Module. The full assortment of 9910DA-AV-EQ Rear I/O Modules is shown and described in 9910DA-AV-EQ Rear I/O Modules (p. 2-6) in Chapter 2, “Installation and Setup”. Technical Specifications Table 1-1 lists the technical specifications for the 9910DA-AV-EQ 9910DA-AV-EQ Analog Video Distribution Amplifier with EQ card. -
Page 12: Warranty And Service Information
(1) year. Cobalt Digital Inc.'s (“Cobalt”) sole obligation under this warranty shall be limited to, at its option, (i) the repair or (ii) replacement of the product, and the determination of whether a defect is covered under this limited warranty shall be made at the sole discretion of Cobalt. -
Page 13: Contact Cobalt Digital Inc
Introduction Contact Cobalt Digital Inc. Contact Cobalt Digital Inc. Feel free to contact our thorough and professional support representatives for any of the following: Name and address of your local dealer • Product information and pricing • Technical support •... - Page 14 This page intentionally blank 1-10 9910DA-AV-EQ PRODUCT MANUAL 9910DA-AV-EQ-OM (V1.2)
-
Page 15: Chapter 2 Installation And Setup
Note: Some Rear I/O Modules have the input shield connector tied to GND at the rear I/O module. When used with these rear I/O modules, differential input is not available and jumper should be set to default single-ended position. See 9910DA-AV-EQ Rear I/O Modules (p. 2-6) for more information. 9910DA-AV-EQ-OM (V1.2) - Page 16 Note: Some Rear I/O Modules are not equipped with a LOOP OUT connector. When used with these rear I/O modules, jumper should be set to default TERM (terminated) position. See 9910DA-AV-EQ Rear I/O Modules (p. 2-6) for more information. Input AC/DC...
-
Page 17: Installing The 9910Da-Av-Eq Into A Frame Slot
Note: If installing the 9910DA-AV-EQ in a slot with no rear I/O module, a Rear I/O Module is required before cabling can be connected. Refer to Installing a Rear I/O Module (p. 2-5) for rear I/O module installation procedure. - Page 18 Verify that the card is fully engaged in rear I/O module mating connector. Close the frame front access panel. Connect the input and output cables as shown in 9910DA-AV-EQ Rear I/ O Modules (p. 2-6). Repeat steps 1 through 8 for other 9910DA-AV-EQ cards.
-
Page 19: Installing A Rear I/O Module
This procedure is applicable only if a Rear I/O Module is not currently installed in the slot where the 9910DA-AV-EQ is to be installed. If installing the 9910DA-AV-EQ in a slot already equipped with a suitable I/O module, omit this procedure. -
Page 20: 9910Da-Av-Eq Rear I/O Modules
Installing a Rear I/O Module 9910DA-AV-EQ Rear I/O Modules Table 2-2 shows and describes the full assortment of Rear I/O Modules specifically for use with the 9910DA-AV-EQ. Table 2-2 9910DA-AV-EQ Rear I/O Modules 9910DA-AV-EQ Rear I/O Module Description RM20-9910AV-B Provides the following connections: •... - Page 21 Installation and Setup Installing a Rear I/O Module Table 2-2 9910DA-AV-EQ Rear I/O Modules — continued 9910DA-AV-EQ Rear I/O Module Description RM20-9910AV-B/S Split Rear Module. Provides each of the following connections for two 9910DA cards: • Analog video input (ANLG IN) •...
- Page 22 This page intentionally blank 9910DA-AV-EQ PRODUCT MANUAL 9910DA-AV-EQ-OM (V1.2)
-
Page 23: Chapter 3 Operating Instructions
Card-Edge Controls and Indicators (p. 3-3) • Troubleshooting (p. 3-4) • Accessing the 9910DA-AV-EQ Card via Remote Control The 9910DA-AV-EQ card can be remote monitored via DashBoard™ or ® Cobalt Remote Control Panel. Access the 9910DA-AV-EQ card using ® DashBoard™ or Cobalt Remote Control Panel as described below. -
Page 24: Checking 9910Da-Av-Eq Card Information And Status
Click on the card to be accessed (in this example, “Slot 6: 9910DA-AV-EQ”). Checking 9910DA-AV-EQ Card Information and Status The operating status of the 9910DA-AV-EQ card can be checked using DashBoard™. Figure 3-1 shows and describes the 9910DA-AV-EQ card information screen using DashBoard™. -
Page 25: Card-Edge Controls And Indicators
EQ for the frequency response). Note: Full range of this control results in stable (no poles) operation regardless of EQ or gain settings. Freq. Figure 3-2 9910DA-AV-EQ Card-Edge Controls and Indicators 9910DA-AV-EQ-OM (V1.2) 9910DA-AV-EQ PRODUCT MANUAL... -
Page 26: Troubleshooting
Item Checks Verify power presence and • On both the frame Network Controller Card and the 9910DA-AV-EQ, in all characteristics cases when power is being properly supplied there is always at least one indicator illuminated. Any card showing no illuminated indicators should be cause for concern. -
Page 27: Troubleshooting Network/Remote Control Errors
The Cobalt Digital Inc. Technical Support Department will continue to provide advice on any product manufactured by Cobalt Digital Inc., beyond the warranty period without charge, for the life of the product. See Contact Cobalt Digital Inc. (p. 1-9) in Chapter 1, “Introduction“ for contact information. 9910DA-AV-EQ-OM (V1.2) - Page 28 This page intentionally blank 9910DA-AV-EQ PRODUCT MANUAL 9910DA-AV-EQ-OM (V1.2)
- Page 30 Cobalt Digital Inc. 2506 Galen Drive Champaign, IL 61821 Voice 217.344.1243 • Fax 217.344.1245 www.cobaltdigital.com 9910DA-AV-EQ-OM (V1.2) Printed in USA...
Need help?
Do you have a question about the 9910DA-AV-EQ and is the answer not in the manual?
Questions and answers