Grand Cafe CSM07ALP Operator's Manual page 9

Install Knobs to Door Latches
4
Release the Upper Door Latch.
Align the hole of the Knob with the latch
hole.
Insert Screw from rear of the Latch as
shown and tighten.
Repeat steps to Lower Door Latch.
Push latches back to lock
Phillips Head
Sc r ew
3/16"x3/8"
Knob
Note: Refer to page 11
Tank
Install Ignitor Battery
5
Unscrew Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Ignitor Slot
-
+
AA Battery
Ignitor Cap Spring
Check Electrode before proceeding
6
This test will ensure that the Spark Electrode
Tip is properly positioned so your smoker
lights easily and properly.
Electrode Nuts
Spark Electrode Tip
Be sure Control Knob is set to "OFF"
and open both smoker cabinet
position.
to Install LP Gas
3/16"
Burner
doors.
Press the Ignitor Cap. You should hear
a "clicking" sound and you should see
a blue spark. If a spark is present the
Electrode Tip is properly positioned.
Never put your face inside the Smoker.
If no spark is seen, the Spark Gap
needs to be adjusted as follows:
•
Using an adjustable wrench, loosen the
Electrode Nuts and adjust Spark Gap to
3/16" between the Spark Electrode Tip
and Burner.
•
Secure the Electrode Nuts and try the
Electrode Check again. If no "clicking"
sound is heard:
-
AA Battery may be installed back-
wards.
-
Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Install Cooking Components
7
Cooking Grid
Brackets
Cooking Grids
Final Smoker Assembly Step
When you have finished assembling your
smoker be sure that all screws are tight-
ened for safe operation of your smoker.
WARNING
!
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death or
property damage.
9
!