Lighting Instructions - Grand Cafe CSM07ALP Operator's Manual

Check all connections for LP Gas Leaks
Never test for leaks with a flame. Prior to first use,
at the beginning of each season, or every time
your LP Gas tank is changed, you must check for
gas leaks. Follow these three steps:
Make a soap solution by mixing one part liquid
detergent and one part water.
Turn the smoker Control Knob to the full OFF
position, then turn the gas ON at source.
Apply the soap solution to all gas connections.
If bubbles appear in the soap solution the
connections are not properly sealed. Check
each fitting and tighten or repair as necessary.
WARNING
!
If you have a gas leak that cannot be repaired by
tightening, turn off the gas at the source, disconnect
fuel line from your smoker and call 1-800-761-5456
or your gas supplier for repair assistance.
Never disconnect the gas regulator or any gas fitting
while your smoker is lit. A lit smoker can ignite
leaking gas and cause a fire or explosion which
could result in property damage, personal injury or
death.
Disconnecting A Liquid Propane Gas (LPG)
Tank From Your Smoker
Make sure the Burner Valve and LP Gas tank
valve are off. (Turn clockwise to close.)
Detach the hose and regulator assembly from
the LP Gas tank valve by turning the Quick
Coupling Nut counterclockwise.
USE AND CARE INSTRUCTIONS
!
Smoker Lighting Instructions
1.
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way,
do not use your smoker before replacing the hose with
an authorized part from the Parts List. Also make sure
all gas supply connections are securely tightened.
2.
Familiarize yourself with the safety and Use and Care
instructions in this manual. Do not smoke while lighting
smoker or checking gas supply connections.
3. Be sure the LP Gas tank is filled.
Open both smoker cabinet doors during lighting.
4.
Check that the end of Burner Tube is properly located
over Valve Orifice.
5.
WARNING
!
Failure to replace a faulty hose, secure gas supply
connections or to open the doors before proceed-
ing to the Lighting Procedures could result in a fire
or explosion that could cause serious bodily injury,
death, or property damage.
6. Open the LP Gas tank valve SLOWLY 1/4 of a turn.
OFF
Push and turn the Control Knob to HIGH/IGN and
7.
immediately press the Electric Ignitor for 3-4 seconds
to light the Burner.
HIGH/IGN
If ignition does not occur in 5 seconds, turn the burner
8.
Control(s) off, wait 5 minutes, and repeat the lighting
procedure. If ignition does not occur within 5 seconds,
turn the Control Knob and gas source OFF and conduct
a leak test of ALL gas connections and gas sources as
explained in the Use and Care section of your manual.
If no leaks are detected, wait 5 minutes for any gas to
clear and repeat the lighting procedure.
9. After Burner is lit, turn the tank valve SLOWLY one more
1/4 of a turn for 1/2 of one complete turn.
12
Open LP Gas tank
OFF
LOW
PRESS
!